Polymer-tool friction coefficient in temperature for thermoforming numerical simulation - Université de Pau et des Pays de l'Adour Accéder directement au contenu
Communication Dans Un Congrès Année : 2023

Polymer-tool friction coefficient in temperature for thermoforming numerical simulation

Résumé

In this work, friction coefficient between Polycarbonate and Aluminum was measured over the entire thermoforming temperature range by using a rotational rheometer with a specific geometry, following the B. Hegemann et al. [1] method. The effects of velocity, pressure and surface roughness were investigated. Then, numerical simulation were performed using a finite element code package for thermoforming (T-SIM®) with K-BKZ viscoelastic model. The objective of this work is to find which friction coefficient use in T-SIM simulation to be as close as possible to reality. For this, numerical simulation results for different friction coefficient were compared with experimental values to evaluate the predictive capacity. It was shown that friction coefficient is temperature dependent and rapidly increase above glass transition of polycarbonate. At room temperature, friction coefficient increases with an increase in roughness, but after glass transition, trend is reversed. Simulations with measured friction coefficients shows good agreement with experiment data.
Fichier principal
Vignette du fichier
MS14_328_Caubet_submited-checked.pdf (682.88 Ko) Télécharger le fichier
Origine : Fichiers produits par l'(les) auteur(s)

Dates et versions

hal-04295358 , version 1 (20-11-2023)

Licence

Paternité

Identifiants

Citer

Benoit Caubet, Frédéric Léonardi, Sylvain Amand. Polymer-tool friction coefficient in temperature for thermoforming numerical simulation. International ESAFORM Conference 2023, Apr 2023, Cracovie (PL), Poland. pp.1907-1916, ⟨10.21741/9781644902479-206⟩. ⟨hal-04295358⟩
39 Consultations
13 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More